Tengdi technical requirements for a hot saw

Our requirements for heat saws: 

Low noise, isolation and absorption. 

The front and rear guide sleeves improve the quality of the nozzle and remove the tail. The bottom of the saw cover is slope-shaped, and the slope is larger. Add a water blowing mechanism to clean the iron filings at the bottom of the saw cover. Timed blowing, the blowing duration is adjustable.

Add idler rollers at the front and rear to avoid wear of the guide sleeve.

Clamping can be canceled to improve synchronous tracking ability. (Cancellation is not recommended). Double pump, clamp independent pump.

The pulling structure, the anti-holding wheel can be canceled, which is equivalent to reducing the car body and reducing the wear of the guide rail. 

The cylinder base is strengthened to prevent any vibration and damage. The critical part that bears the sawing force. 

The position of the oil cylinder can be adjusted to adapt to the wear of the saw blade. The adjustment amount is generally 50mm.

The small wheels are installed on the outside of the car body and are easy to disassemble. 

When the wheel is worn, the height of the wheel axle can be adjusted. Avoid the three-legged phenomenon when the wheels are worn. 3mm.

Add a keyway and a cross key between the saw arm support and the saw box body. (After passing the factory acceptance, it will be welded before leaving the factory). Here is the non-fragile part.

The 5V belt is used for the motor belt, and the transmission torque is 3-5 times that of the B-type belt and 2-3 times that of the C-type belt. The pulley has a protective cover.

The linear speed of the saw blade ensures that the steel pipe has no large internal and external burrs, and the intermediate linear speed is selected according to the actual range, wall thickness range, and outer diameter range. (The user provides the outer diameter, wall thickness and material of the steel pipe. 195-355B).

The DC solenoid valve coil is added with a freewheeling

Post time: Oct-09-2022